Electrolux EKF900 Mode D'emploi page 5

EN
11. When the brewing process is finished, allow coffee to stop dripping and then remove the carafe
to serve.
For a new brewing cycle, switch off the appliance and allow a few minutes for it to cool down. Then
you can refill the water tank.
SETTING DELAY BREW TIME (AUTOMATIC BREWING)
To program your coffee maker to brew at a later time, first check that the time is set correctly.
1. In standby state and the display shows clock time, touch
mode.
• The display will show the text "TIMER".
2. While "TIMER" is displayed, repeatedly touch H and M respectively or you can press the key and
hold until the desired brewing time is displayed on screen, then release it.
3. Repeatedly touch to set the desired intensity of aroma.
• The display will show the corresponding symbols.
light mild
4. Touch twice to activate the automatic brewing.
• The white indicator light will illuminate.
• You can check the delay brew time by touching
• To deactivate the automatic brewing, touch
5. When the delay brew time is reached, your coffee maker will begin the brewing cycle.
• The white indicator light will go out whilst the orange indicator light will illuminate.
AROMA FUNCTION
The taste of your coffee can be optimised by touching the aroma button
The aroma button activates a unique brewing process that enhances the flavor and aroma of your
coffee.
• To activate this function, in the standby state touch
displayed. Touch to brew coffee.
• To deactivate this function, in the standby state repeatedly touch
symbols disappear from the display.
AUTOMATIC SHUT-OFF
For safety, this coffee maker features the automatic shut-off protection.
When a brewing cycle is finshed, the coffee maker will automatically turn off after 35 minutes.
twice to enter the timer setting
strong
.
again. The display will show clock time.
.
. The corresponding symbols will be
until all the aroma
6
CLEANING AND MAINTENANCE
Turn off and unplug the appliance from the mains socket. Allow the appliance to cool
down before cleaning.
• Clean the outside of the appliance with a slightly damp cloth. Dry thoroughly.
• Never immerse the appliance in water.
• Clean the removable parts in warm soapy water with a soft brush or cloth then rinse
them thoroughly.
• Do not use abrasive or chemical cleaning agents.
DESCALING
Regularly descale the appliance using a specific descaler.
1. Fill the tank with water and descaler to the max line. (Refer to the descaler
instructions for the scale of water and descaler.)
2. Place the carafe onto the plate.
3. Plug in the appliance and then touch
4. After descaling, rinse out the appliance by operating the appliance using water at
least twice (two full tanks of water).
TROUBLESHOOTING
Problem Possible Cause
The carafe is leaking. The carafe is not inserted properly.
The coffee drops too slowly
Coffee grounds is too fine.
or overflows from the edge of
The filter is too dirty.
the removable funnel.
There is coffee residue in the
The filter is blocked.
carafe.
Water leaks from the bottom There is leftover water in the
of the coffee maker. machine.
The coffee maker heats in an
abnormal state, which causes
The coffee maker is not
the safety protective system to
working.
activate.
The machine lacks water.
SPECIFICATIONS
Ratings: 220-240V~ 50-60Hz 900W
.
Solution
Make sure the center of the jug
aligns with opening of the
funnel.
Use coarser coffee powder.
Rinse the filter with water.
Clean the filter.
Do not use the coffee mak-
er again, contact customer
service.
The coffee maker should be
able to work after keeping it
still for 30 seconds, otherwise
contact customer service.
Fill the machine with enough
water.
7
EN