Kimpex 374457 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
P P olaris – Ranger XP 800
9) Assemble one (1) M8-1.25 x 20 mm hex. bolt
one (1) M8-1.25 hex. nut
V-plate . Tighten the bolt with an appropriate tool.
A
D
A
10) Assemble the V-plate
by first aligning the rear carriage bolts
front carriage bolts
D
01
11) Once the four (4) carriage bolts
the bottom of the slotted holes of the attachment
plate , tighten them well using an appropriate
01
tool.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810514 A A -2810514 rev. A Printed in Canada
ASSEMBLY INSTRUCTIONS
F
at the front centre of the
E
F
E
on the attachment plate
A
, then the
D
.
are inserted to
D
and Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 3. Refer
to the instructions for the push frame for the assembly
procedure. It is possible that the position must be
changed to fit the winch installed on the vehicle.
01
374457
KIMPEX NO.
3