Arrêt; Couper L'alimentation; Minuterie Et Mise En Veille; Setting The Timer - Mcculloch Rob R600 Manuel D'utilisation

START button is not pressed, a message beep is heard
and the robotic lawnmower will not start.
4.4 Arrêt
1. Appuyez sur le bouton STOP.
Le robot tondeuse et le moteur de coupe s'arrêtent, puis
le capot s'ouvre.

4.5 Couper l'alimentation

1. Appuyez sur le bouton STOP.
2. Placez l'interrupteur principal en position
Éteignez toujours le robot tondeuse à l'aide de
l'interrupteur principal s'il nécessite un entretien ou si
vous devez le sortir de la zone de travail.

4.6 Minuterie et mise en veille

Utilisez la fonction de minuterie (voir
pour éviter que votre pelouse ne soit aplatie.
4.6.1 Mise en veille
Le robot tondeuse est programmé avec une période de
veille prédéfinie en fonction du tableau relatif à la durée
de veille. Cette période de veille peut par exemple être
mise à profit pour arroser ou jouer sur la pelouse.
Modèle
McCULLOCH ROB R600
McCULLOCH ROB R800
McCULLOCH ROB R1000 4

4.6.2 Setting the timer

When setting the timer, calculate that the robotic
lawnmower mows about the amount of the number of
square meters per hour and day listed in table Work
capacity.
36 - Fonctionnement
0 .
Timerà la page23 )
Veille, nombre minimum
d'heures par jour
11
8
Model
McCULLOCH ROB R600
McCULLOCH ROB R800
McCULLOCH ROB R1000 48 / 520
If the working area is for example 360 m
ROB R1000 must operate for 7,5 hours a day. The times
are approximate and depend for instance on grass
quality, blade sharpness and battery age.
AVERTISSEMENT : Use the timer to avoid
mowing when there are usually children, pets
and anything else that could be damaged by the
rotating blades on the lawn.
The factory setting for the timer is 07:00 am - 11:00 pm
and it allows mowing every day of the week. This setting
is suitable for the listed maximum working area.
If the size of the working area allows it, the quality of the
grass can be further improved if it is cut every other day
instead of a few hours every day. In addition, the grass
benefits from resting completely during at least a three-
day period once a month.
4.6.3 Example 1
The times used in this example are applicable to
ROB R600, but the principle is the same for other
models.
Period 1 : 07:00 am - 11:00 pm
Timer setting,
Active period (A): 07:00 am - 08:00 pm
The factory setting ensures that the robotic lawnmower
begins cutting the lawn at 07:00 am. However the
mower is parked in standby mode in the charging station
from 08:00 pm and rests until it starts cutting again at
07:00 am.
If the timer setting is divided into 2 work periods, the
standby period can be divided into a number of periods.
The minimum standby period time must however be
according to the Standby time table.
Approximate work capaci-
2
ty, m / sq. ft per hour and
day
43 / 460
50 / 538
2
/ 3875 in. size,
436 - 001 - 09.10.2017