Charging The Battery - alphatronics Sound S-40 Mobile Mode D'emploi

ENGLISH ENGLISH
7 Preset
Short press: Open "preset" favourites list > select mode
Long press: Open "preset" favourites list > storage mode
8 Auto Tune
Long press: DAB: start automatic station search
FM: start search for next station
9 Source
Short press: Switch between individual sources
Long press: Open settings
4.4 LED CODES
The (left) LED...
... has a solid red light The soundbar is charging
... is flashing red
... goes out
The (right) LED
... is flashing blue
... has a solid blue light
... has a solid green light
... has a solid white light
5. COMMISSIONING
5.1 ASSEMBLING THE ROD AERIAL
The telescopic rod aerial is screwed in using an F-connector. This means that other antennae with F-connectors
aside from the one provided can be attached to the device. Assembly: Screw the antenna into the appropriate
connector on the rear of the device then adjust the antenna and tighten the knurled nut again so that the antenna
is fixed to the F-connector.

5.2 CHARGING THE BATTERY

In its factory settings, the battery is only slightly charged. Therefore, it must be fully charged before initial use.
Open the protective cap on the back of the device and plug the type C USB charging cable into the corresponding
port. Now connect the charging cable to an appropriate adapter to begin charging. A charging adapter with at
least a 2A power output is required for this.
Low battery - please connect the product to a power source
The soundbar is fully charged
The soundbar is in Bluetooth® "pairing mode"
The soundbar is connected to a Bluetooth® device
The soundbar is in AUX-In mode
The soundbar is in HDMI™ mode
21