Eaton E5024E0432 Notice De Mise En Service page 2

3. Selection of the displayed value
Pressing the right key allows switching between
the totalizer display and the frequency meter dis-
play. Press the key briefly to display the current
function ("count" or "tAcho") for 2 seconds. If,
during this period of time, the right key is
pressed a second time, the device switches to
the current function and displays a confirmation
("count" or "tAcho") for 2 seconds. Then, the
value of the selected function is displayed.
4. Setting of the operating pa ra me ters
a. Press both front side keys and switch on the
supply voltage or, if the supply voltage is
already on, press both keys simultaneously
for 5 s.
b. The display shows
c. After releasing the keys, the display shows
c1.Hold the left key pressed and press the right
key to exit the programming operation.
c2. Press the right key to switch to
d. Hold the left key pressed and press the right
key to switch to the first parameter.
e. After releasing the keys, the display alternates
between the menu title and the current menu
item. After pressing any key, only the menu
item setting is displayed.
f. Pressing the right key will switch the menu
item setting to the next value.
If figures are to be input (e.g. when setting the
scaling factor), select first the decade using
the left key, and then set the value using the
right key.
g. Hold the left key pressed and press the right
key to switch to the next menu item.
2
.
h. The last menu title "EndPro" allows the user,
when selecting "YES", to exit the program-
ming menu and to store the new values. If
"no" is selected, the programming routine is
repeated, the latest values set remaining
active. They can now be checked again or
modified.
5. Programming routine
The programmable parameters of the device are
described below, in the order in which they can
be set. The device is fully programmed after one
pass of the routine.
The first values stated correspond to the factory
settings.
5.1 Polarity of the inputs
npn: sinking sensor
pnp: sourcing sensor
MN05401004E