Assembly & Operation - Worx Nitro DRIVESHARE WG186 Mode D'emploi

ASSEMBLY & OPERATION
Action
Assembly
Assembling the Trimmer Shaft
Insert the screw into the hole,
then tighten the locking collar.
Assembling the Auxiliary Handle
Assembling the Safety Guard
Insert the metal bracket into the
slot on the safety guard, then
secure the guard in place using
the screw and hex key.
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run
when 2 batteries are installed.
It is recommended to use
the same two batteries and
charge the two batteries at
the same time.
• When two batteries are used
with different amp hours or
charge level, the machine will
run to the lowest common
denominator.
• It is recommended that
using 4.0Ah or above battery
pack for better performance
and longer run time.
Checking the battery charge
condition
NOTE: Fig. D3 only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
Operation
Cordless DRIVESHARE
String Trimmer
To start
Figure
after the trimmer has been
switched off; wait until it has
completely stopped then lay
down the tool.
See Fig. A
Press the lock-off button first, then
press the switch trigger to start
See Fig. B1, B2
the machine.
ECO Speed
For longer run time, press the
See Fig. C
ECO button and switch trigger,
then your machine will operate at
a low speed.
Trimming
Bump feed
Assembling and removing the
trimmer head
Insert the hex key into the hole
and rotate the trimmer head
until it stops in a locked position.
Then, rotate counterclockwise
See Fig. D1, D2
to remove it, and clockwise to
assemble it.
Winding the trimmer line
NOTE: The spool must be wound
while inside the trimmer head.
The spool cannot be wound
with line, then installed into the
trimmer head.
ATTACHMENT-CAPABLE
See Fig. D3
ACCESSORIES
The below attachment accessories are sold
separately to convert the grass trimmer into a tool for
various applications.
See Fig. D4
1. Pole hedge trimmer attachment (WA0220)
This attachment is intended for cutting and trimming
hedges and bushes in domestic use.
2. Brush cutter attachment (WA0221)
This attachment is intended for cutting thick brush.
See Fig. D5
3. Pole saw attachment (WA0222)
This attachment is intended for sawing of trees, tree
trunks, branches, limbs, etc. Cuts can be sawed with
or across the grain. This product is not suitable for
sawing mineral materials.
4. Edger attachment (WA0223)
This attachment is intended for edging around
walkways, driveways, flower beds, etc.
WARNING! The cutting
head continues to rotate
See Fig. E
See Fig. F
See Fig. G
See Fig. H
See Fig. I
See Fig. J
9
EN