Plusmed pM-NT 01 Mode D'emploi page 17

* Please consult your doctor, if this or any other problem occurs repeatedly.
Other possible malfunctions and their elimination – If problems occur when using the device, the following points
should be checked and if necessary, the corresponding measures are to be taken:
Malfunction
The display remains empty when
the instrument is switched on
although the batteries are in place.
The pressure does not rise al-
though the pump is running.
The device frequently fails to meas-
ure the blood pressure values, or
the values measured are too low
(too high).
Every measurement results in dif-
ferent values although the device
functions normally and the values
displayed.
The blood pressure values meas-
ured differ from those measured
by the doctor
Further information
The level of blood pressure is subject to fluctuations even with healthy people. Important thereby is, that comparable
measurements always require the same conditions (rest conditions)!
You must consult your specialist dealer or chemist if there are technical problems with the blood pressure instru-
ment. Never attempt to repair the instrument yourself!
Any unauthorised opening of the instrument invalidates all guarantee claims!
Remedy
1. Check whether the batteries are installed with the correct polarity and
correct if necessary.
2. If the display is unusual, re-insert batteries or exchange them
• Check the connection of the cuff tube and connect properly if necessary.
1. Fit the cuff correctly on the arm.
2. Before starting the measurement make sure that the cuff is not fitted
too tightly and that there is no rolled-up sleeve ex- erting pressure on
the arm above the measuring position. Take off articles of clothing if
necessary.
3. Measure the blood pressure again in complete peace and quiet.
• Please read the following information and the points listed
under «Common sources of error». Repeat the measurement.
• Record the daily development of the values and consult your
doctor about them.
17