Operation - Duronic HV052 Manuel D'utilisation

3. Press the button on the front display
panel. The screen will indicate the room
temperature and power indicator light. It
will start off on low settings.
4. Press to increase the power to
"High power setting", press
to decrease the power to "Low power
setting".
5. Press the 'Temp' button, then the room
temperature will be on the display screen,
the defaulted temperature is 25˚C.
There is 5-36˚C which can be set as you
desire. You can press
temperature, the settings will be effective
in 6 seconds.
The heater will remain on until the room
temperature increases to your desired
temperature. It will stop heating while at
the desired temperature, when the room
temperature is 2˚C less than the desired
temperature, it will start heating again.
This cycle will repeat to maintain the
desired room temperature.

Operation

to change
12