Vax AirRevolve C85-AC-PH-E Mode D'emploi page 27

It is imperative that you read the chapter "For your safety" before you work with the appliance.
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attach-
ments, or removing and emptying the dust bin.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum
cleaner does overheat the thermostat will automatically turn the vacuum cleaner off. If this happens,
switch the vacuum cleaner off and unplug. Remove and empty the dust bin also check the vacuum
cleaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned
the filter please wait 24 hours for the filter to fully dry before putting back into the machine).
Assembling your vacuum cleaner
Line up hose connector with
hose entry point.
Line up and push the other end
of the telescopic tube into the
powered head until it clicks into
place.
Push hose connector into hose
entry point until hose connector
clicks and locks into place.
Slide the length adjuster on
the telescopic tube and select
required length.
Before you start
Line up handle with telescopic
tube. Push handle into telescopic
tube until it clicks and locks into
place.
GB
27