Airxcel MAXXAIR MINI 3700 Directives D'installation Et Guide D'utilisation

MAXXAIR
MAXXFAN MINI, MAXXFAN MINI PLUS
INSTALLATION INSTRUCTIONS,
INFORMATION AND OPERATING GUIDE
MAXXFAN MINI PLUS MODELS 3801, 3851
NOTE: Refer to Installation Instructions, Information and Operation Guides regarding the model you
have purchased.
The MAXXAIR MINI / MAXXFAN MINI / MINI PLUS installs into a standard RV roof opening
of 14 by 14 inches.
To determine if your roof opening is correctly sized, simply remove the interior ceiling garnish trim ring
of your existing roof vent and measure the ceiling opening or verify the opening is large enough by
sliding the MAXXAIR MINI / MAXXFAN MINI / MINI PLUS sleeve into the opening.
The MAXXAIR MINI / MAXXFAN MINI / MINI PLUS is designed for a minimum roof thickness
of 1 inch to a maximum of 4 1/2 inches.
The MAXXFAN MINI / MINI PLUS requires a minimum 12 Volt DC, 2 amp service.
that the circuit you intend to use will accommodate the additional load. Circuit must be fused and use
appropriate gauge stranded wire for electrical connections.
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a) Use this unit only in the manner intended by AIRXCEL, INC. If you have questions, contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service panel.
CAUTION! FOR GENERAL VENTILATION USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR
EXPLOSIVE MATERIALS AND VAPORS.
MAXXAIR MINI
FOR MAXXAIR MINI MODELS 3700, 3750
MAXXFAN MINI MODELS 3800, 3850
READ AND SAVE THESE INSTRUCTIONS
Confirm
P/N: 10D03708Z
05-2019