Control Mode; Operation Mode - Gewiss GW 10 763 Mode D'emploi

The thermostat can be set to 2 different control modes:
• Slave: the function depends on the device configured as Master (for instance the Easy
EIB timer-thermostat GW 10 761), that set the thermostat operation type and mode.
In this function mode the thermostat uses the set-point values that are set locally. It
is possible to change the set temperature set-point (max variation ± 3 °C), whilst it
is not possible to change the operation mode. The modified set-point will remain valid
until the Master device sends a new operation mode.
• Stand alone: The thermostat operation type and mode are set locally. The operation
status does not depend on any other device In Stand-alone mode it is possible to vary
the set-point at will and enable the thermostat to receive remote commands from
other devices, such as for instance a button or the EIB Easy GSM remote control unit
GW 90 861.
The thermostat foresees 4 different operation modes:
• ECONOMY
• PRECOMFORT
• COMFORT
• OFF-FROSTPROTECT/HIGH TEMPERATURE PROTECTION
In the STAND ALONE control mode use the
In the SLAVE control mode the
the device configured as Master.
GENERAL DESCRIPTION
Control modes

Operation mode

key is not enabled, as the operation mode is set on
In the economy, precomfort and comfort operation
modes the timer-thermostat permanently uses the
corresponding temperature set-points.
The current ambient temperature and the symbol
o
38
key to switch from one mode to another.
appear on the screen.
,