Troubleshooting - Frigidaire EFIC450 Manuel De L'utilisateur

TROUBLESHOOTING

PROBLEM
" " ADD WATER" indicator is
on.
" FULL ICE" indicator is on.
The big reservoir full of
water, but " ADD WATER"
indicator is always on.
No water flow out from the
water separator pipe.
No water in the unit, but the
" ADD WATER" indicator is
not on, unit can not make ice
cube.
Ice cube is too weak and
thin.
Ice making cycle is normal
but no ice is made.
P OSSIBLE CAUSE
Lack of Water.
There is too much ice.
The water is distillation water, it
is too pure.
The water filer at bottom of the
water reservoir is blocked. And
water can't enter into the lower
water tank.
The hole on the wall of the water
separator is blocked.
The water is not enough pure.
Maybe you have used the salt
water or others.
The wall of the lower tank
underneath the ice basket is too
dirty.
The ambient is too hot.
Ambient temperature or water
temperature in inner tank is too
high.
Refrigerant liquid leakage.
Pipe in the cooling system is
blocked.
8
SOLUTION
Stop the ice maker, fill water from
the top big water reservoir up to
FULL mark, then press "ON/OFF"
button again to restart the unit.
Remove ice from ice basket.
Chang the water to nomal potable
water or mineral water.
Clean the water filter.
Use slim wire to prick each hole,
till the water can flow out easily.
Chang to the normal potable
water.
The salt water is prohibited, it will
damage your unit.
Clean this water tank.
Turn off you unit first, then press
"ON/OFF" button again for more
than 5 seconds to turn on the unit
again. It will lengthen
ice-making cycle time.
Please run the ice maker below
90 ℉ and pour colder water into
tank.
Verify by a qualified technician.
Verify by a qualified technician.
each