DANSANI Hydra Mode D'emploi page 9

Timer Operating Instructions
GB
This appliance has a timer function with 3 operating modes:
1. Continuous Operation:
a) Press On/Off button once
The towel rail enters standby mode.
b) Press On/Off button one more time, the display
shows with a dot flashing in the bottom left hand
corner. The towel rail starts heating.
** Press On/off button at anytime when the timer is working
to turn off the timer. The towel rail stops heating.
2. Timed Operation:
a) Press On/Off button , once, the timer displays
The towel rail enters standby mode.
b) Press time button to set the time which the towel rail
work , the time can be set from 1 hour to 12 hours.
c) Press On/Off button one more time to confirm the
time, the display shows
bottom corner. The towel rail starts heating for the set
time, and counts down until it turns off automatically.
** Press On/off button at anytime when the timer is working
can turn off the timer. The towel rail stops heating.
3. 24-Hour Timer:
a) Press On/Off button , once, the timer displays
The towel rail enters standby mode.
b) Press time button to set the time which the rails work
, the time can be set from 1 hour to 12 hours.
c) HOLD On/Off button for 3 seconds to confirm the
time, the display will flash twice and shows
dot flashing in the bottom corner. The towel rail starts
heating for the set time, and counts down until it turns off
automatically.
d) When the timer reaches zero, the display will read
and the towel rail will enter sleep mode. The display
will flash intermittently to indicate that the towel rail is in
sleep mode. The towel rail will automatically turn on at
the same time every day according to when the 24-Hour
Timer was activated: e.g. if it was activated at 7am for 1
hour, the towel rail will turn on at 7am every day for 1 hour.
, the timer displays .
.
with a dot flashing in the
.
with a
e) Press On/off button at anytime when the timer is working
can stop the timer. The towel rail enters sleep mode. You
may press On/Off button once to enter standby mode
and one more time to cancel the 24-Hour Timer by
manual.
** During Timed Operation mode, you can change the time
by HOLDING the time button
display flashes once, then you can re-set the time. Once
you set the right time, leave it there for 3 seconds. The
display will flash twice to start again auto- matically. The
timer will count down until it turns off automatically.
DANSANI
for 3 seconds. The