Turning The Power On And Off - Tascam MZ-223 Mode D'emploi

Connecting headphones
Connect headphones to the PHONES (
dard stereo).
You can monitor input channel pre-fader signals and
signals before they are sent to the stereo output bus.
Use the MONITOR SELECT (
outputs that you want to monitor.
CAUTION
Before connecting headphones, minimize the vol-
ume with the PHONES VOLUME (
to do so could result in a sudden loud noise that
could harm hearing, for example.
NOTE
Sounds output from headphones are affected by
the output equalizers.
Connecting stereo amplifiers
When connecting a stereo amplifier, connect it to the
MAIN OUTPUTS 1–3 (UNBALANCED) (
OUTPUTS 1–3 (BALANCED) (
TIP
i When connecting 2 or more amplifier and speaker
systems, including main and sub, main and mon-
itoring, or front and rear combinations, using the
MAIN OUTPUTS 1–3 (UNBALANCED) (
MAIN OUTPUTS 1–3 (BALANCED) (
be convenient. Moreover, the outputs of the jacks
are independent and have their own dedicated
output knobs, so you can set the output levels
separately with this unit.
i By connecting a recorder to MONITOR OUT (
jacks, the signal output to amplifier/speaker sys-
tems can be recorded.
12
TASCAM MZ-223
) jack (stan-
s
) switches to select the
r
) knob. Failure
a
) or MAIN
v
) jacks.
c
) and
f
) jacks could
c

Turning the power on and off

CAUTION
i Turn down the volume of the sound system con-
nected to the unit before starting up or shutting
down the unit.
i Do not wear connected headphones when turn-
ing the unit on and off. Loud noises could damage
the speakers or harm your hearing.
Before turning the power on
1.
Make the following settings on the front of the
unit.
o EQ knobs w center values
o Other knobs w all the way left (MIN side)
o Faders w all the way down
o Switches w off (not pushed in)
2.
Minimize the output levels of audio sources and
input levels of amplifiers connected to this unit.
Turning the power on
1.
Use the POWER (
unit to turn its power on.
The POWER (
will light when on.
2.
Turn connected input audio source devices on.
3.
Finally turn amplifiers on.
Turning the power off
)
x
Follow the procedures above in reverse when turning
the power off.
Failure to follow the correct order could result in click-
ing noises, for example, that might damage equip-
ment.
) switch on the back of the
f
) indicator on the front of the unit
t