GBC ClassicCut CL100 Manuel D'utilisation page 5

Operating the Guillotine
Place the guillotine on a stable, flat surface such as
1
a table.
Lift cutting arm into cutting position.
2
D. Ensure the safety guard is installed. With the left
3
hand, hold the material securely in place to be sure
that it remains square to the blade while cutting.
Cutting Restrictions
• Remove staples, paper clips etc. before cutting.
• Do not cut metal film, film containing glass etc.
• Do not cut more sheets than cutting capacity allows.
• Do not carry guillotine by holding on to the
cutting blade or the cutting arm.
• Always operate guillotine with both hands and on a
stable base or desk.
• Check the fittings of the blade and safety cutting
guard from time to time.
Service
Do not attempt to service or repair the unit yourself. If
your guillotine is under warranty return it to the point of
purchase for replacement or repair. If your guillotine is
no longer under the point of purchase return period and
requires replacement or repair, please contact your
supplier for further assistance.
Guarantee
Operation of this machine is guaranteed for two years
from date of purchase, subject to normal use. Within
the guarantee period, GBC will at its own discretion
either repair or replace the defective machine free of
charge. Defects due to misuse or use for inappropriate
purposes are not covered under the guarantee. Proof of
date of purchase will be required. Repairs or alterations
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 96333500
Use Grid and ruler to ensure a precise cut.
4
When finished using the guillotine, always place the
5
cutting arm in the down position and secure the
handle safety latch.
made by persons not authorised by GBC will invalidate
the guarantee. It is our aim to ensure that our products
perform to the specifications stated. This guarantee
does not affect the legal rights which consumers have
under applicable national legislation governing the sale
of goods.
5