Akai Professional MPD24 Manuel De L'opérateur page 23

PROGRAM CHANGE – PARAMETERS
MIDI Port/Channel
field
Program Change
field
Bank M
Bank L
Note:
You can also configure pads to send Program Change messages
only, without specifying Bank M and Bank L. While editing
Bank M and Bank L fields of a pad, use [VALUE] dial to set
Bank M and Bank L to 'OFF' (beyond 000). This will cause the
pad to transmit only a Program Change message.
MIDI Channel field
Program Change messages can be sent on one of two MIDI
Ports, A or B, and one of 16 MIDI Channels on each port (i.e.
A7). You may also assign Program Change to use the MIDI
Common Channel.
1. Use [ < ] or [ > ] button to select MIDI Port/Channel
field.
2. While in MIDI Port/Channel field, use [VALUE] dial to
select desired MIDI Port and Channel.
3. Use the [ > ] button to select the next field.
Program Change field
In this field you can set which Program Change Number the
pad will transmit when it is pressed.
1. Use [ < ] or [ > ] button to select Program Change field.
2. While in Program Change field, use [VALUE] dial to
select desired Program Change Number.
Use the [ > ] button to select the next field.
3.
Bank M
Bank M describes the Most Significant Bit (MSB) of
information.
1. Use [ < ] or [ > ] button to select Bank M field.
2. While in Bank M field, use [VALUE] dial to select
desired value.
3. Use the [ > ] button to select the next field.
Bank L
Bank L describes the Least Significant Bit (LSB) of
information.
1. Use [ < ] or [ > ] button to select 'Bank L' field.
2. While in Bank L field, use [VALUE] dial to select
desired value.
17