Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AC3 Series
Electrical Infrastructure Requirement
Required Circuit Breaker on AC Mains
Required Ground Fault Protector on AC Mains
Required AC Mains Cable
Vehicle charge cable
WALL MOUNTING WARNINGS
1) Read the instructions before mounting your charging station on the wall.
2) Do not install the charging station on a ceiling or inclined wall.
3) Do not install the charging station near heating devices.
4) Use the specified wall mounting screws and other accessories.
5) This unit is rated for indoor or outdoor installation.
6) If this unit is mounted outdoors, the hardware for connecting the conduits to the unit must be rated for
outdoor installation and be installed properly to maintain the proper IP rating on the unit.
Required Tools for Installation
•(1x) Drilling Machine
•(1x) Drill bit Ø8mm
•(1x) Hammer (for Screw Anchor)
•(1x) Torx T25 ( Security ) Screwdriver
•(1x) Torx T20 Screwdriver
•(1x) Phillips PH2/PH3 Screwdriver
•(1x) Flat(Slot type) Screwdriver
•(1x) Spirit Level (Water level)
•(1x) Wire Cutters
•(1x) Mains Tester Screwdriver
230VAC 50/60 Hz - 1-phase 16A
2P-20A MCB Type-C
20A - 30mA RCCB Type-A
3 x 4mm² (< 50m)
Outer Dimension: Ø 12-18 mm
Type 2 socket compatible on charging station side
English - 2 -
Publicité
Table des Matières
