Lock Function - Airwell RC08C Guide D'utilisation

OPERATIION
When the room temperature reaches the new set value, the thermostat will cause
the unit to pause. After about 1 hour the temperature will be raised by 1 °C in
cooling, or lowered by 1 °C in heating. This enables you to save energy without
sacrificing your comfort.
COOLING AND DEHUMIDIFYING
Setting temperature
Setting temperature Room temperature
1 hour 1 hour TIME
I FEEL/ROOM TE MP FUNCTION OPERATION
Press button I FEEL to activate the I FEEL function. Thermometer sign will appear on
the LCD operation display .Select suitable temperature setting. Make sure that
the remote control unit is aimed at the air conditioner. Prevent the I FEEL sensor from
being affected by heat sources such as lamps, heaters, direct sun, etc. or from being
directly affected by the air conditioner air flow.These may cause the sensor to transmit
the wrong temperature data, thereby disturbing the performance of the I FEEL function.
Press again on I FEEL button, the measured room temperature sign
displayed .
To cancel the ROOM Temperature display press on one of the following:
- Press again on I FEEL button.
- Change of MODE button.

LOCK FUNCTION

By pressing - and + bottoms simultaneously to lock the last operation program. All the
function buttons will be inoperative, including POWER button. By pressing both buttons
again the remote control will be released from its locked position.
HEATING
Room temperature
1 hour 1 hour TIME
will be
9
SETTING THE TIMER
There are four timers that can be selected on the remote control. Two daily timers (desigated
as T1,T2), and two optional weekend timers(designated as WKT1, WKT2). Each timer can
be selected by pressing TIMER button.
The daily timers T1 and T2 can be set for ON and OFF separately for two different time
periods.
Timer setting will not change until new setting is input.
The weekend timers WKT1 and WKT2 can be set for ON and OFF separately for two
different time periods and they are effective two days only. These timers will be effective on
the day of setting and on the day after only.
At 24:00 on the second day, the WK timer will not be effective anymore and the daily timer
will be effective again.
WKT1 - effective on the setting day.
WKT2 - effiective one day afgter the setting day.
NOTE:
1. During the weekend timer operation, the daily timers will not
be disabled.
2. The WK timers must be reactivated every weekend.
A) HOW TO SET THE ON TIMER
1. Press the TIMER button to select the desired timer.
2. Press the SET button till the ON sign blinks.
3. Press the + or - button until the desired valve is displayed.
4. Press the SET button to activate the timer.
B) HOW TO SET THE OFF TIMER
1. Press the TIMER button to select the desired timer.
2. Press the SET button till the OFF sign blinks.
3. Press the + or - button until the desired valve is displayed.
4. Press the SET button to activate the timer.
10
OPERATIION
MODE CLR
TIMER SET
SLEEP
TURBO
ECO
ION
I FEEL EYE
CLEAN LIGHT