Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION! To protect the seal prior to installation, the ball is raised and is therefore not leak tight. Before
using the valve, press 'On" to move the ball to the "FILTRATION" position.
Off
1
Press this key to shut down the device, irrespective of the valve position.
ON = Start position
2
Press this key, the device starts up and the valve moves to the start position "FILTRATION "
(the yellow indicator lamp is illuminated).
teSt BUttON
3
Before pressing this key, put the valve in the start position
Press TEST BUTTON, the back wash cycle starts and runs long enough to complete one
recirculation (the green indicator lamp lights up).
DrAiN
4
Before pressing this key, put the valve in the start position
Upon pressing this key, the valve moves to the "DRAIN" position (the red indicator lamp lights
up). Water is pumped to waste.
recirculation
To move the 6-way valve to "CIRCULATION" and then "FILTRATION",
follow these steps:
- First, move the valve to the start position
- Press the keys "TEST BUTTON" and "DRAIN"
simultaneously and keep them held down until the green
indicator lamp lights up (minimum 4 sec).
CAUTION! After simultaneously pressing the "TEST
BUTTON" and "DRAIN"
keys, the green indicator lamp lights up followed by the
red indicator lamp. Finally, the green indicator lamp flashes
and the valve moves to the "CIRCULATION" position.
- After the CIRCULATION cycle, press the "OFF " key.
-
Come back to the start position.
KeY PaD FunctiOnS
QUALITY
I
I
R
SERVICE
INNOVATION
Praher
EIN
PRÜFTASTE
3
ON
TEST BUTTON
AUS
ENTLEEREN
2
1
OFF
DRAIN
2
.
20/36
2010/03 - Indice de révision : A - Code : 0026700
!
2
!
2
4
I
I
R
Praher
Publicité
Table des Matières
