Intended Use; Technical Description; Safety Features; Product Overview - Kampa Geyser Instructions De Montage Et De Service

Intended use

The water heater is suitable for:
• Supply of heated water for washing up, cleaning
and showering outdoors
The water heater is not suitable for:
• Supply of drinking water
• Use as a cooking appliance
• Operation in enclosed buildings, tents or
awning tents
• Operation on caravans, mobile homes or boats
• Wind speeds > 10 kph
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Kampa reserves the right to change product
appearance and product specifications.

Technical description

This water heater is designed to raise the outlet
water temperature by an average of 25 °C above
the source water temperature. Temperature can
be adjusted using the temperature control knob.
The water flow can be adjusted using the water
flow regulation switch.
The appliance can be moved by a carrying handle.
A carry bag allows for easy transport.
12

Safety features

Over-temperature sensor
The appliance will not allow the burner to remain in
operation once the outlet water temperature
reaches 50 °C. The burner will automatically
relight once the outlet temperature falls below
50 °C.
Water flow sensor
Water must be flowing through the system to allow
the burner to ignite. In case the water supply is
restricted or ceases, i.e. the shower head switch is
in the "OFF" position, the burner will be extin-
guished and will not relight until the water flow
recommences.
Tilt switch
In the event that the appliance is moved during
operation the appliance will shut down and must
be switched off until a suitable surface is located.

Product overview

No. in
fig. 2,
page 3
1
2
3
4
5
6
7
8
9
10
11
4445103340
Designation
Burner exhaust
Temperature control knob
Carrying handle
Burner viewing window
Gas inlet
Water outlet tap
Water inlet
12 V power socket
Water pump power socket
On/off switch
Water flow regulation switch