Klarfit Myon Cross Mode D'emploi page 51

Step 6
A Pull the upper cap C of the front post (04) off.
B Pull out the two sensor wire plugs (A) of the fixed handlebar (14)
through the hole C. Pull them up through the upper center hole.
C Then attach the fixed handlebar (14) onto the front post (04), tighten
by 2 washers (68), 2 bolts (69) and 2 nuts (70).
D Connect the upper sensor wire of the computer (12) to the lower sensor
wire (13) and connect the pulse sensor wire (A) to the sensor wire of the
hand pulse (11). Then secure the computer with 2 bolts (10).
EN
51