IEM Mobil-O-Graph PWA Mode D'emploi page 121

Buttons of the Mobil-O-Graph
®
The Mobil-O-Graph has 4 buttons which can be used to perform various functions:
ON/OFF button
You can turn the Mobil-O-Graph
switching on or off, the button must be held down for at least 2 seconds.
You can also prematurely terminate the measuring process with this button, as well as with any
other button. The pressure in the cuff is then quickly released.
START button
The START button is used to start the automatic log and triggers an additional manual
measurement. In addition, pressing the START button will allow you to continue the
measurement cycle if you have terminated a blood pressure measurement by pressing any
button, or if you have switched the Mobil-O-Graph
trigger an additional single measurement; however, this should only be done after consultation
with the doctor. Special events are recorded using the EVENT button, see EVENT button.
DAY/NIGHT button
Press the DAY/NIGHT button in the evening before going to bed and again in the morning when
you get up. Pressing the DAY/NIGHT button is stored together with the measurement results
and allows your doctor to carry out a more detailed evaluation.
EVENT button
Press the EVENT button to record an event which may affect the blood pressure and to trigger
an additional measurement. Pressing the EVENT button is stored together with your
measurement results and allows your doctor to carry out a more detailed evaluation. Make a
note of the circumstances of the event in a personal measurement log so that you can discuss
the events with your doctor afterwards. Special events are, for example, taking medication, chest
pains, shortness of breath or similar.
®
®
on and off using the ON/OFF button. To avoid accidental
®
off and back on again. The button can also
Appendix
EN
119