Progressive Scan - Cambridge Audio 80 Serie Mode D'emploi

CONNECTION TO A PROGRESSIVE SCAN TV/DISPLAY
Some televisions and monitors are equipped with component video
inputs and are capable of reproducing a progressively scanned video
signal. Connecting to these inputs allows you to view higher quality
pictures with less flicker.
To enable progressive scan via the component output please refer to
page 13 under general setup to explain how to access this in the menu.
If you find that you have no display but are
getting sound from your speakers, you have set
the DVD player to progressive scan mode.
Simply press the I-Scan button on your remote
control.
85/86/89 DVD player
Y Y P P r r P P b b
Audio In
Audio Cord
If your progressive scan TV has Y, Pb Pr video inputs you can use the
players Y, Cb/Pb, Cr/Pr outputs . Press the P-Scan button to switch the
player to the progressive scan video output mode.
If this player's audio outputs are also connected to the TV, the L/R
channels of 2-CH OUT should be connected to the TV's AUDIO IN
terminals.
It is imperative that you use high quality component video cables to
ensure the best possible performance.
Rear Panel
N N o o t t e e : : TV set with progressive-scan
video input
80 series DVD player 19