Braun Silk-epil 9 Mode D'emploi page 8

Our products are engineered to meet the
highest standards of quality, functionality
and design. We hope you thoroughly
enjoy using your Braun Silk·épil 9.
Please read the use instructions carefully
before using the appliance and keep
them for future reference.
Braun Silk·épil 9 has been designed to
make the removal of unwanted hair as
efficient, gentle and easy as possible.
The extra wide epilation head removes
the shortest hair (0.5 mm / 0.02 in) from
the root, leaving your skin smooth for
weeks.
Important
• For hygienic reasons, do not share this
appliance with other persons.
• When switched on, the appliance must
never come in contact with the hair on
your head, eyelashes, ribbons, etc. to
prevent any danger of injury as well as
to prevent blockage or damage to the
appliance.
Description
1a High frequency massage cap
1b Skin contact cap
2 Extra wide epilation head
TM
3 SensoSmart
4 Switch with lock keys (4a)
5 Charging light
6 Release button
7 Special cord set
8 Facial cap*
9 Shaver head with trimmer cap
* not with all models
Charging
Using the special cord set (7) connect
the appliance to an electrical outlet and
charge it for 2 hours.
Charging light (5)
Flashing green: charging
Green: fully charged
Yellow: 15 minutes charge left
Flashing yellow: 5 minutes charge left
8
light
• Once fully charged, use the appliance
cordless. Operation time is 50 minutes
when it is used within 24 hours after
charging. Recharge it when the yellow
light comes on or when the motor has
stopped completely. For best per-
formance, always use a fully charged
appliance.
• Wet usage might reduce the operation
time. We recommend that you
recharge the appliance after each use.
• The best temperature range for
charging, using and storing the appli-
ance is between 59 °F and 95 °F.
In case the temperature is far beyond
this range, the charging time might be
longer whereas the cordless operation
time might be reduced.
At the end of its lifetime, the recharge-
able battery can be replaced at an
authorized Braun Service Center.
How to operate the appliance
Press one of the lock keys (4a) and turn
the switch (4) clockwise to position «I» or
«II». The SensoSmart
as long as the appliance is switched on,
thus providing good visibility of fine hairs.
When you apply too much pressure, the
TM
SensoSmart light signals red.
To remove the epilation head (2), press
the release button (6).
To change caps, press their lateral ribs
and pull off.
A Epilation
Epilation tips
If you have not used an epilator before,
or if you have not epilated for a longer
period of time, it may take a short time
for your skin to adapt to epilation. The
discomfort experienced in the beginning
will decrease considerably with repeated
use as the skin adapts to the process.
When epilating for the first time, it is
advisable to epilate in the evening,
so that any possible reddening can
TM light (3) shines