Ecco EC7008-WK2 Instructions D'installation page 8

CAMERA MODEL EC2027-WC2
INSTALLATION AND MOUNTING:
Important! Mount the camera at a location that provides the best view of the area immediately behind the vehicle. Generally, mounting locations toward the
top of the vehicle provide the best field of view. Lower mounting locations reduce the field of view and increase the likelihood of damage from road spray.
Carefully remove the unit from its packaging. Examine the unit for transit damage. If damage is found, return the product to your local dealer for war-
ranty replacement. Do not use damaged or broken parts.
U-BRACKET CAMERA MOUNTING INSTRUCTIONS:
1. Select a level surface for installation.
2. Drill mounting holes using the lower U-bracket as a template and attach the U-bracket with user supplied hardware.
3. Install the camera and sun-visor on the U-bracket as shown in Figure 6.
4. Adjust the camera's position for the best viewing angle before tightening the two screws on each end.
5. Attach the antenna so that it is vertical as shown in Figure 7.
WIRING INSTRUCTIONS:
Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with insulation tape. Wrap tape tightly,
overlapping by one-half widths so there are no gaps.
The unit is designed for electrical systems from 12 to 24 VDC (10 to 30 VDC extremes).
The wiring for all systems is:
Red Wire Positive (+)
Black Wire Negative (-)
All wiring should be a minimum of 20 AWG. A 3-amp fuse in the positive
line is required (see Figure 8).
Figure 6
For reference only
Figure 7
3
Figure 8
Page 8 of 9