Accessories - Reer Basic 46221 Mode D'emploi

Step 5
Mark the positions of the 4 clamping shells (f). Ill. 15
Screw the holding cups with the wooden mounting screws (k) tight onto the wall.
installing the
clamping shells
Lift the grid back out of the mounting device and turn the adjusting screw (c) on the grid tray B (b)
until the gap between the pressure foot of the grid tray A (a), which is not extended and the
mounting surface is exactly 4 mm. Ill. 16
You may need to try several times.
ATTENTION: Ensure that the pressure foot is firmly on the floor.
Put the gate back on the clamping shell.
Handling the door gate
To lift the handle, gently press both buttons simultaneously. Lift handle gently from the back /
bottom. If the buttons are pressed too hard, this complicates lifting the handle. Lift gate, remove
from the support shells and swing to the side. Ill. 24
When closing the door, ensure that the pressure foot below and the adjustment screw at the top
are positioned correctly in the support shells when the closure handle is lowered.

Accessories

Clamp Board
Art.No. 46906
Information
Suitable for all clamping and screwed gates. Solves almost every installation problem with stair
railings. Installation on round or angular railing struts possible. Suitable for railings with a thickness
of 0 to 80 mm
Please keep the sales receipt, operating manual and article number in a safe place.
All claims based on warranty or guarantee are to be directed solely towards the retailer.
// optionally available
- 14 -