Connecting The Interface; Initial Calibration - Pioneer PX Serie Mode D'emploi

EN-3

2.4 Connecting the Interface

The PX balance has two data interfaces, RS232 and USB.
Use the RS-232 port to connect either to a computer or a printer with a standard (straight-through)
serial cable. Use the USB port to connect to a computer with a USB 2.0 Type A to Type B cable.
Interface connections on the rear of the balance
USB RS232
USB: Used to connect to PC only
RS232: Used to connect to PC or Printer
Note: For Connecting, Configuring and Testing the Printer / Computer Interface, see the Printing
section.

2.5 Initial Calibration

For best results, the instrument's calibration should be checked prior to first use. If adjustment is
needed, refer to the Calibration section of the instruction manual.
3. OPERATION
3.1 Overview of Controls and Display
The PX balance has a 2-line backlit display.
CONTROLS