Facom CL2.C1913D Notice D'instructions page 17

Intended use of the machines :
- The CL2.P1913D drill-screwdrivers are designed to screw, unscrew, and drill. These machines are not designed to drill tough construction materials
(concrete, cement, rock, ....)
- The screwing/unscrewing torque setting is for indication only, and is not a substitute to a thorough checking with a torque wrench,
should this be required by the assembly.
Using the machine:
- Apply the safety instructions provided in this manual.
- Fit the tool on the chuck: turn the knurled section of the chuck clockwise to open the chuck, then in the opposite direction and
lock tightly to maintain the tool in the chuck.
- Select the running direction: selector mark 2
- Select the rotation speed: selector mark 5 ;
- « high » position: high speed, low torque
- « low » position: low speed, high torque
- Set the rotation strength (torque): selector mark 6; 15 different screwing torques are available
(torque increases according to the number on the selector),
and 1 "no torque limitation"position for drilling.
Torque varies according to the ''high'' or ''low'' position selected.
- To start, press the trigger (mark 1) gradually.
The variator allows for increasing the rotation speed according to the pressure on the trigger.
For safety reasons, the chuck is stopped when the trigger is released.
- To improve visibility, you can switch on the built-in LED light (button mark 3).
Do not omit to switch off the LED light after use (switch off after 15 min)).
Do not change the speed, rotation direction, or screwing torque while the motor is running.
Recommendations of use:
Accessories:
- Only use accessories adapted to the task at hand and to the machine used; your safety, the quality of your work and the tool lifetime depend on it.
The FACOM range includes drill bits, screwing bits and screwing sockets suited to your needs (see <<FACOM accessories>> section).
Drilling:
- When drilling large diameter holes or in tough materials, we recommend starting by making a smaller hole first.
Noise and vibration in machine:
Values measured in compliance with the EN 60745 European Standard
The actual value measured for continuous acoustic pressure weighted equivalent A is 70,65 dB (A) for the machine.
The value for acoustic power is 81,65 dB (A) for the machine.
Always use ear protection for any work !
The vibration transmitted in the forearm and the hand is 12,21 m/s
EC STATEMENT OF COMPLIANCE:
WE, FACOM S.A.S., 6/8 RUE GUSTAVE EIFFEL - BP 99 - 91 423 MORANGIS CEDEX FRANCE, STATE UNDER OUR LIABILITY THAT THE FOLLOWING PRODUCTS:
CL2.P1913D – DRILL-SCREWDRIVER 13 MM - 19,2 VD.C BY FACOM
COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING EUROPEAN DIRECTIVES:
- ''MACHINES'' DIRECTIVE 2006/42/EC
- ''LOW VOLTAGE'' DIRECTIVE 2006/95/EC
- ''EMC'' DIRECTIVE 2004/108/EC
AND COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING HARMONISED EUROPEAN STANDARDS:
- EN 60745
- EN 55014
- EN 60335
2 for the machine.
5 6
1
2
20.01.2010
Manager
The FACOM Quality
17