Safety information
NOTICE!
A
To prevent damage when drilling, make sure there is sufficient
space on the other side for the drill head to come out.
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
When testing the voltage in electrical cables, only use a diode
test lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too
high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
Insulate all connections.
Secure the cables against mechanical wear with cable binders
or insulating tape, for example to existing cables.
2.2
Operating the device safely
WARNING!
!
Never play videos while you are driving to avoid dangerous sit-
uations in road traffic. Adhere to the country-specific laws and
regulations.
Only use the device in its function as a reversing video system
while driving. The driver must not look at the monitor under any
circumstances while driving along. This could distract the driver
and lead to a serious accident.
Adjust the volume of the device so that noise from traffic, partic-
ularly horns and beeps, are still able to be heard.
Protect the device from humidity and moisture to prevent
sparks, fire or electric shocks.
Switch off the device immediately
– if water gets into the device,
– if smoke is coming out of the device or
– if the device emits an unusual smell.
26
MC402
EN