Télécharger Imprimer la page

Braun BrewSense Touch Screen Mode D'emploi page 11

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
Installing the Charcoal Water Filter (A)
Use of the charcoal water filter is optional, but
strongly recommended. The filter eliminates
chlorine, bad tastes and odors from tap water.
The coffee maker will operate normally without it.
Replacement water filters can be purchased in
stores, through the Braun website, or by calling
Customer Service.
• Remove the charcoal water filter (7) from polybag
and soak in cold tap water a minium of 15
minutes.
• Remove the charcoal water filter holder (8) from
the coffee maker by lifting it out of the water
reservoir (3).
• Gently press down the stem and pull toward you.
Compartment will flip open.
• Place the charcoal water filter in the water filter
holder and close it; you will hear a snap indicating
it is in place.
• Hold the filter under cold running tap water for
10 seconds to flush. You should place the hole
openings directly under the water stream.
• Allow the filter to drain completely.
• Position the green indicator to the month you
installed the charcoal water filter. We recommend
changing the charcoal water filter every 2 months,
more often if you have hard tap water.
• Replace the charcoal water filter holder in the
water reservoir of the coffee maker, pushing it all
the way down to the base of the unit, along the
reservoir wall.
NOTE: Caution must be used when inserting the
charcoal water filter. Improper placement in the
water filter holder can cause tearing of the filter
skin.
Switching On/Off
• To switch on the coffee maker, press the On/Off
button (1). The green indicator light will illuminate
indicating that the coffee maker is in «ready»
mode. Time of day and the last selected brewing
mode are displayed.
• To switch off the coffee maker, press the On/Off
button again. The green indicator light will turn off
indicating that the coffee maker is in «stand by»
mode. Time of day remains visible.
NOTE: If the On/Off button is pressed and no
further function is selected within 30 seconds the
coffee maker goes into "stand by" mode. The last
selected brewing mode and the LED of the On/Off
button disappear. To get out of stand by mode,
press the On/Off button.
Programming the Coffee Maker
Before programming, always switch on the
coffee maker.
NOTE: The coffee maker features a 60-second
power loss back-up system that remembers all
programmed information, including time of day and
auto on/off times in the event of a tripped breaker,
unit is unplugged, or power failure.
Changing the Time
• Press CLOCK for a minimum of 1 second.
• For further steps refer to «Settings».
Changing the Water Hardness
• Press CLEAN (c) for a minimum of 1 second.
• The pre-set water hardness level starts flashing.
• For further steps refer to «Settings».
Programming the AUTO ON Time
• Press AUTO ON (b) for a minimum of 1 second.
• The time of day in the display starts flashing.
• Press and hold SET (e) to scroll through the
hours. Release it once the desired hour is
displayed.
• To set the minutes, press AUTO ON. The minutes
in the display starts flashing.
• Press and hold SET to scroll through the minutes.
Release it once the desired minutes is displayed.
• Press AUTO ON to save the desired time.
• The pre-set auto on time disappears after a few
seconds and the time of day shows on the display
• This function can only be activated if the auto on
time and the time of the day have been set.
To activate the AUTO ON function:
• In order to customize the way your coffee will
brew, you will need to 1) select your brew mode
(f) (fast, regular, or bold) and 2) activate the 1-4
cup (g) if you will be brewing a small amount of
coffee.
• Press AUTO ON (b). AUTO ON illuminates and the
coffee maker starts to brew at the pre-set auto on
time.
• The pre-set auto on time disappears after a few
seconds.
• When the appliance starts brewing, BREW will
continually flash and AUTO ON turns off.
• Press AUTO ON (b) again to switch off the
function: AUTO ON will disappear.
NOTE: The AUTO ON function remains activated
and illuminated even when the appliance has been
switched off (1).
11

Publicité

loading

Ce manuel est également adapté pour:

Kf 7370