Publicité
Les langues disponibles
Les langues disponibles
To delete a card user by card. Note
users can be deleted continuously
without exiting programming mode
To delete a card user by user ID. This
option can be used when a user has
lost their card
To add a card and PIN user in card and PIN mode ( 3 1 # )
To Add a card and Pin user
(The PIN is any four digits between
0000 & 9999 with the exception of
1234 which is reserved.)
To change a PIN in card and PIN
mode (Method 1) Note that this is
done outside programming mode
so the user can undertake this
themselves
To change a PIN in card and PIN
mode (Method 2) Note that this is
done outside programming mode
so the user can undertake this
themselves
To delete a Card and PIN user just
delete the card
To add and delete a card user in card mode ( 3 0 # )
To Add and Delete a card user
TO DELETE ALL USERS
To delete all users. Note that this is
2 0000 # a dangerous option so use
with care
TO UNLOCK THE DOOR
For a PIN
For a card User
For a card and PIN user
16
EN
All manuals and user guides at all-guides.com
2 Read Card #
2 User ID #
Add the card as for a card user Press
* to exit from the programming mode
Then allocate the card a PIN as follows:
* Read card 1234 # PIN # PIN #
* Read Card Old PIN # New PIN #
New PIN #
* ID number # Old PIN # New PIN #
New PIN #
2 User ID #
The operating is the same as adding and
deleting a card user in 3 2 #
2 0000 #
user Enter the PIN then press #
Read card
Read card then enter PIN #
Door settings
RELAY OUTPUT DELAY TIME
To set door relay strike time
To disable door open detection.
(Factory default)
To enable door open detection
Changing the master code
Changing the master code
For security reasons we recommand changing the master code from default.
G- TECHNICAL FEATURES
> Very low power consumption (<30 mA)
> Voltage DC 12V +/-10%
> Badge reading distance 3-6 cm
> Active current < 60mA
> Stand-by current 25±5mA
> Lock load output 3A max
> Operating temperature -35°C ~ 60°C
> Degree of humidity : 10% - 90% RH
> Relay output delay time
> Possible wiring connections : electric lock, gate automation, exit button
> Backlight keys
> 100 users, supports badge, PIN, badge + PIN
> Full programming from the keypad
> Can be used as a stand alone keypad
> The keyboard can be used to remove the lost badge number, thoroughly eliminate
the hidden safety trouble
> Adjustable Door Output time, Alarm time, Door Open time
> Fast operating speed
> Lock output current short circuit protection
> Indicator light and buzzer
* Master code # 4 0~99 # * 0-99 is
to set the door relay time 0-99 seconds
6 0 #
6 1 #
0 New code #
New code #
The master code consists of 6 to 8 digits
EN
17
Publicité
Chapitres
