F- Using; F1- Fast Programming; F2- Detailed Programming Guide - SCS Sentinel CodeAccess A Notice D'utilisation Et D'installation

F- USING

F1- Fast programming

Programming a code
Enter Default master code (999999)
programming
code
User number Confirm
(from 1 to 100)
Programming a badge
Enter
Default master code (999999)
programming
code
Present the badge(s) to the keypad (each
programmed badge will automatically
increment the user number)
Door opening
Trigger the opening through user code
Programmed user code
To trigger the opening with a badge, you only have to present the badge to the keypad.
14 EN
All manuals and user guides at all-guides.com
Confirm Add a code
User code to 4 digits Confirm
(except 1234)
Confirm Add a badge
Exit
programming
mode
Confirm

F2- Detailed Programming Guide

User Settings
To enter the programming mode
To exit from the programming mode
Setting the working mode:
Set valid card only users
Exit
Set valid card and PIN users
programming
Set valid card or PIN users
mode
To add a user in either card or PIN mode, i.e. in the 3 2 # mode.
To add a PIN user
To delete a PIN user
To change the PIN of a PIN user
(This step must be done out of
programming mode)
To add a card user (Method 1) This is
the fastest way to enter cards, user
ID number auto generation.
To add a card user (Method 2) This
is the alternative way to enter cards
using user ID Allocation. In this
method a user ID is allocated to a
card. Only one user ID can be
allocated to a single card.
* Master code #
999999 is the default factory master code
*
Note that to undertake the following programming
the master user must be logged in
3 0 # Entry is by card only
3 1 # Entry is by card and PIN together
3 2 # Entry is by either card or PIN (default)
(Default setting)
1 User ID number # PIN #
The ID number is any number between 1 & 100.
The PIN is any four digits between 0000 & 9999
with the exception of 1234 which is reserved.
Users can be added continuously without exiting
programming mode as follows: 1 User ID no 1 #
PIN # User ID no 2 # PIN #
2 User ID number # Users can be deleted conti-
nuously without exiting programming mode
* ID number # Old PIN # New PIN #
New PIN #
1 Read card # Cards can be added continuously
without exiting programming mode
1 ID number # Read card # User can be added
continuously without exiting programming mode
EN
15