Maintenance Instructions - BE 317RA Mode D'emploi

MAINTENANCE INSTRUCTIONS

Caution: Only a certified electrician can service the
motor. Contact an authorized dealer for service or
additional information.
User Maintenance Instructions:
General Inspection: Inspect the motor at regular intervals, approximately
every 500 hours of operation or every 3 months, whichever occurs first. Keep
the motor clean and the ventilation openings clear. Check that the interior and
exterior of the motor is free of dirt, oil, grease, water, etc. Oily vapor, paper
pulp, textile lint, etc. can accumulate and block motor ventilation. If the motor
is not properly ventilated, overheating can occur and cause damage to the
motor over time.
Lubrication & Bearings: Lubrication from bearing grease will degrade over
time. The lubricating ability of grease depends primarily on the type of grease,
the size of the bearing, the speed at which the bearing operates, and the
severity of the operation conditions. Optimal results can be obtained if the
following recommendations are utilized in your maintenance routine.
Type of Grease: A high grade ball or roller bearing grease should be used.
Recommended grease for standard service conditions is Polyrex EM (Mobil).
Equivalent and compatible grease include:
Texaco Polystar, Rykon Premium #2, Pennzoil Pen 2 Lube and Chevron SRI-2.
- Maximum operating temperature for standard motors=110°C.
- Shut-down temperature in case of a malfunction = 115°C.
Lubrication Intervals: Recommended lubrication intervals are every
2200hours. For more information contact an authorized service center.
28
STARTING YOUR ELECTRIC WASHER
WARNING
To reduce the risk of electrocution, keep all
connections dry and off the ground. Do not touch
plug with wet hands
How to Start Your Electric Pressure Washer
To start your pressure washer for the first time, follow these instructions step-
by-step. This starting information also applies if you have let the pressure
washer sit idle for at least a day.
1. Place pressure washer near an outdoor water source capable of supplying
water at a flow rate greater than 3.8 gallons per minute and no less than 20
PSI at the end of the garden hose. DO NOT siphon supply water.
2. Ensure unit is level and placed on a flat, even surface.
3. Connect garden hose to water inlet on pressure washer pump.
NOTICE
DO NOT run the pump without the water supply connected and turned on.
• Damage to equipment resulting from failure to follow this instruction
will void warranty.
4. Attach wand extension to spray gun. Tighten by hand.
.
5 Choose desired spray tip, pull back nozzle extension collar, insert spray
tip and release collar. Tug on spray tip to make sure it is securely in
place. See Spray Tips for information on each type.
6. Uncoil high pressure hose and attach quick connect end of hose to the
base of the spray gun. Pull down on collar of quick connect, slide onto spray
gun and let go of collar. Tug on hose to ensure the connection is tight and
secure. If the connection is even slightly loose, disconnect and try again.
29