When Update Fails - Samsung HW-T400 Manuel

Masquer les pouces Voir aussi pour HW-T400:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35

When update fails

1. Turn off the Soundbar, disconnect and then
reconnect the USB storage device that
contains the update files to the Soundbar's
USB port.
2. Disconnect the Soundbar's power cord,
reconnect it, and then turn on the Soundbar.
NOTES
– The firmware update may not work properly
if audio files supported by the Soundbar are
stored in the USB storage device.
– Do not disconnect the power or remove the
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
– After the update is completed, the user setup
in the Soundbar is initialised so you can reset
your settings. We recommend you write
down your settings so that you can easily
reset them after the update. If the software
update fails, check if the USB stick is
defective.
– Mac OS users should use MS-DOS (FAT) as the
USB format.
– Updating via USB may not be available,
depending on the USB storage device
manufacturer.
ENG - 30

Publicité

Table des Matières
loading

Table des Matières