Start Up; Installing The Handle; Water Connection - Kärcher HDS 3.0/20 C Ea Mode D'emploi

Start up

Warning
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
 Lock parking brake.

Installing the handle

Figure 3
Screw tightening torque: 6.5-7.0 Nm
Install the tool bag
Figure 4
 Hook the tool bag onto the top tabs on
the appliance.
 Tilt the tool bag down and lock it into
place.
 Fasten the tool bag with 2 screws
(torque: 6.5 - 7.0 Nm).
Install the hand-spray gun, the jet
pipe, the nozzle and the high pres-
sure hose
Figure 5
 Connect ray tube with hand spray gun
 Tighten the screw connection of the
spray lance finger tight.
 Insert high pressure nozzle into cover-
ing nut
 Install covering nut and tighten firmly
 Connect the high pressure hose to the
high pressure connection point of the
machine.
Installing spare high pressure hose
Figure 6
Refill system care
The system care prevents the calcifica-
–
tion of the heating spiral while operating
with calciferous tap water. It is dosed
into the supply in the float container
drop by drop.
The metering is set to medium water ri-
–
gidity by the manufacturer
Note: A sample bundle of system care is in-
cluded.
 Refill system care.
Danger
Risk of explosion! Only refill diesel oil or
light fuel oil. Unsuitable fuels, e.g. petrol,
are not to be used.
Caution
Never operate device with empty fuel tank
The fuel pump will otherwise be destroyed.
 Refill fuel.
 Close tank lock.
 Wipe off spilled fuel.
Refill detergent
Caution
Risk of injury!
Use Kärcher products only.
–
Under no circumstances fill solvents
–
(petrol, aceton, diluting agent etc.)
Avoid eye and skin contact.
–
Observe safety and handling instruc-
–
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
 Refill detergent.

Water connection

For connection values refer to technical
specifications
 Attach supply hose (minimum length
24.6 ft/7.5 m, minimum diameter 3/4")
to the water supply set by means of a
hose clamp.
 Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note: The supply hose and the hose clamp
are not included in the scope of delivery.
Suck in water from vessel
If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:
– 4
EN
Refill fuel
11