Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
1.
Unwrap the cord and plug the unit into a standard 115V
GFCI-protected outlet. CAUTION: Be sure switch is in the
off position before connecting unit to power outlet.
2.
For ventilation, direct the Stealth outlet where desired. For
drying, direct the outlet toward the surface to be dried.
Secure the airmover orientation by tightening the knobs on
either side of the unit.
3.
When finished, unplug the unit and re-wrap the cord in the
cord wrap.
Electrical safety devices
Circuit breaker: If the circuit breaker detects overload or short
circuit conditions, the breaker will automatically shut off the
Fig. B: Disassembly for cleaning
Remove the four screws as shown and lift off the front assembly.
Retain screws for reassembly. Do not overtighten screws.
Fig. C: Stacking for storage or transport
07-02189E F568
electrical supply. If this should occur, check the power cable
carefully for any damage and ensure it is plugged into a properly
grounded outlet. Press the Circuit Breaker Reset Switch (Fig. A)
to reestablish the electrical supply.
TRANSPORT AND STORAGE
Always use the handle to load or carry the unit.
For cord storage, wrap cord around housing in groove. Pull cord
snug and secure with plug clip (Fig. A).
Units may be stacked up to five high for transport and storage
(Fig. C). To stack, tip first unit back onto its outlet side and nest
additional units on top (Fig. A).
When transporting, secure the unit(s) carefully to prevent sliding
and damage to the unit and/or injury to vehicle occupants.
Keep unit dry. Do not expose the unit to rain or snow.
MAINTENANCE
WARNING: Unplug unit before performing any maintenance.
Before each use
Inspect the power cord. If cord is damaged, do not use. Always
grasp the plug (not the cord) to unplug.
As needed
Clean housing and impeller. If dust accumulation is visible in the
interior, remove the four screws from the outlet grill as shown
(Fig. B). Clean impeller assembly and all surfaces with
pressurized air and/or with a soft cloth. Do not apply liquids to
the impeller assembly. The housing may be cleaned with a mild
solution of detergent and warm water. Ensure housing is
completely dry before reassembling.
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the
Dri-Eaz Service Department at 800-932-3030.
SPECIFICATIONS
Model
Volts
Frequency
Amp draw
Power (motor rating)
Weight
Dimensions
(D × W × H)
Units per 15 amp
circuit
Air movement
Static pressure (H
O)
2
Sound level (avg.)
Control
Cord length
Construction
Safety
Specifications are subject to change without notice. Some values
may be approximate.
2
Stealth AV3000 (F568)
115
60 Hz
2.7
0.46 hp / 340W
27.5 lbs. | 12.5 kg
10.8 × 24.3 × 24.0 in.
27.4 × 61.7 × 61.0 cm
Up to 4
2600 CFM | 4417 CMH
0.40 in. | 99 Pa
58–72 dB
Variable speed rotary switch
16 ft. | 4.9 m
Rotomolded polyethylene and injection
molded ABS housing components; steel
wire inlet and outlet grills.
ETL tested to UL and CSA standards
Dri-Eaz Products, Inc.
Publicité
