RISCO Group WL T33S Instructions D'installation page 55

RTTE Compliance Statement
Hereby, RISCO Group declares that this equipment is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. For
the CE Declaration of Conformity please refer to our website: www.riscogroup.com.
CE CPD Approval
The wireless smoke detector, RWT33S86800A, manufactured by:
RISCO Ltd, 38 Haharoshet Street, Kiryat Malachi, ISRAEL
Has been tested and approved according to the CPD directive 89/106/EEC &
93/68/EEC, standard EN54-7/A1:2002 by ANPI, BELGIUM (NB No. 1134)
081334-CPD-047
FCC Note (for 433.92 MHz)
FCC ID: JE4RWT30S433
IC: 6564A-RWT30S
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance, RISCO Group could void the user's authority to operate
the equipment.
* 433.92 MHz: RWT33S43300A
Wireless Supervisor Photoelectric Smoke Detector 55