Pioneer SGX-CA500 Guide De Démarrage Rapide page 24

EN
Troubleshooting
■ You do not know how to initialize.
Cause
■ Sensor information is not displayed.
Cause
The sensor is not paired.
The sensor battery is almost empty. Replace the battery with a new one. Refer to the user's
■ The latitude and longitude are not displayed.
Cause
Reception is poor when inside a
room or in areas surrounded by
mountains.
It may take a few minutes to display
the latitude and longitude when you
use the device the first time.
24
Solution
- Tap [Settings]-[System]-[Setting Manager]-[Initialize] from
the home screen to initialize. Refer to the User's Guide for
details.
If you initialize, the ride log data will be deleted. Save the
data to a PC before initialization.
Solution
Check that the sensor is paired to the device properly. If you
use the pedaling monitor sensor SGY-PM910H/PM900H,
refer to the User's Manual of the SGY-PM910H/PM900H
and Installation Manual.
manual of the sensor for information about how to replace
the battery.
Solution
Use the device outside in an open area.
When you use the device for the first time, you may need to
allow extra time for GPS reception.