casmar BOX1-DCS Mode D'emploi page 18

PROGRAMMING VÍA ADDITIONAL RADIO TRANSMITTERS
WITHOUT "MASTER TRANSMITTER" (PIN-MODE)
STOP
In order to operate in this mode, it is necessary to first insert
an installation "PIN".
This "PIN" is a four-digit number, which is inserted, by means of a MANAGER
or MINIMAN portable programmer, into the first transmitter which is
recorded in the receiver. As from now, the receiver recognizes the
corresponding transmitter and automatically records it in its memory,
indicating this action by means of a very long acoustic signal.
Once a code is recorded in the memory of the receiver card, it cannot be
deleted individually. The codes recorded there can only be eliminated by
erasing the entire memory (performing a "system reset"). To erase the
contents of the memory of the receiver, press the programming button for
5 seconds. After the first second the unit will emit a long "beep" that will
indicate that the unit has entered the programming mode (do not pay
attention to this "beep"). After the 5 seconds, the unit will emit a series of
short intermittent "beeps", indicating that the memory is free and that the
receiver is in the programming mode ready for new commands to be
entered. The installation PIN will remain operative.
Deletion of PIN: Keeping pressed the programming button during 5 seconds
more after the reset, the unit will emit a long serie of short intermittent
"beeps" indicating the deletion of the PIN.
!
Note: in the hypothetical event of the receiver memory being
affected by some unusual external factor, the unit will emit an
intermittent acoustic signal when the transmitter is pressed.
If you are working in this function mode it can
be useful to place readable the sticker "PIN-
MODE" in order to facilitate the programming
procedure by the end user.
DELETION OF MEMORY
17