Klarfit Kiddy King Mode D'emploi page 45

To attach the drawbar
The drawbar is held by a spring pin and a safety pin. Push down the
1 spring pin and slide the drawbar into the holder on the left side of the
trailer as shown.
When the spring pin engages in the hole in the bracket, find the
locking pin (attached to the trailer frame) and insert the pin through
the bracket and into the hole in the drawbar. The locking pin should
2
go completely through the drawbar and the bracket. Once the pin
is through, turn the spring clip upwards until it engages over the pin
head Pull the locking pin to ensure it is securely fastened.
How to close and open the locking pin
open
Insert the locking pin at the
fastening point until it presses
through the opposite hole. Once the
pin is through, turn the spring clip
upwards until it engages over the pin
closed
head. To unlock, proceed in reverse
order.
EN
45