Klarfit Kiddy King Mode D'emploi page 41

Mounting the brakes
Lean the trailer back so that it rests on the handlebars and the front
1
of the trailer is facing upwards.
Position the two holes in the trailer directly in front of the rear
2
wheels.
Insert screws from the inside out through the holes in the frame as
3
shown.
Place the brake assembly on the frame and tighten the screws with
4 the supplied Allen key until they are tight. Repeat the procedure on
the other side, taking care to align the brake assembly.
Note: The nut is secured inside the brake assembly, so you do not need a
wrench or pliers to hold the nut in place when tightening the bolts.
EN
41