Lenz Digital plus POWER3 Mode D'emploi page 9

1 Connecting and installing the POWER3 storage module to the GOLD decoder
The connections of the POWER3 storage module are designed as loose wires. The module is
encapsuated by a heat-shrinking sleeve that protects sensitive components and facilitates
installation. It also serves to prevent short-circuits to the metal components inside the locomotive -
do not remove it from the module on any account.
The POWER3 storage module measures approx. 32,0 x 10,6 x 25,0 mm.
GOLD decoders are equipped with soldering surfaces or screw terminals to which the cables of the
POWER3 storage module must be soldered or screwed. The precise location of these surfaces is
described in the respective decoder manual:
GOLD mini:
GOLD:
U+
charge
GND
U+
charge
GND
9
E