Battery Warnings - Tripp-Lite SmartPro SMART1500CRMXL Manuel Du Propriétaire

Important Safety Instructions
• The plug on the power supply cord is intended to serve as the disconnect device. Be sure
that the socket-outlet is installed near the equipment and is made easily accessible.
• Be sure to provide an easily accessible local disconnect device on permanently
connected models.
Caution! This UPS receives power from more than one source.
Disconnection of the AC and DC sources is required to de-energize the unit
before servicing.
Equipment Connection Warnings
• Use of this equipment in life support applications where failure of this equipment
can reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended.
• Do not connect surge protectors or extension cords to the output of the UPS. This might
damage the UPS and may affect the surge suppressor and UPS warranties.

Battery Warnings

• Batteries can present a risk of electrical shock and burn from high short-circuit current.
Observe proper precautions. Do not dispose of the batteries in a fire. Do not open the
UPS or batteries. Do not short or bridge the battery terminals with any object. Unplug
and turn off the UPS before performing battery replacement. Use tools with insulated
handles. There are no user-serviceable parts inside the UPS. Battery replacement
should be performed only by authorized service personnel using the same number
and type of batteries (sealed Lead-Acid). Tripp Lite offers a complete line of UPS
System Replacement Battery Cartridges (RBC). Visit Tripp Lite on the Web at
www.tripplite.com/products/battery-finder to locate the specific replacement battery for
your UPS. The RBC Type can also be found on the label affixed to the Battery Retention
Plate.
• During hot-swap battery replacement, the UPS will not provide backup power in the event
of a blackout or other power interruptions.
• Do not operate the UPS without batteries.
• See Batttery Replacement section for additional details.
External Battery Connection Warnings
• When adding external battery packs to select models with external battery pack
connectors, connect only Tripp Lite-recommended battery packs of the correct voltage
and type. Do not connect or disconnect battery packs when the UPS is operating on
battery power. Visit www.tripplite.com/products/battery-finder to locate the supported
battery type(s) for your UPS.
19-01-060-932757.indb 3
3
1/21/2019 9:56:33 AM