Micro Sd Card Installation - Blaupunkt HOS-X20 Manuel

3. Installation
3.1. IMPORTANT – Read before installing
•
Before the installation, please make sure the make sure the wall structure / installation surface can at
least support 3x weight of the LampCam.
•
Check your Wi-Fi signal strength. To make sure that your LampCam's connection is as stable as
possible, make sure that the Wi-Fi signal is very strong at the location of your LampCam. The
suggested Internet bandwidth is 1Mbps (upload/download speed).
•
Recommendation: Avoid the lens aiming directly into the sunshine and if possible install the
LampCam under a roof or eave (Pic.1) or a position which offers a good protection against heavy
rain.
• If you desire to install a microSD card we recommend doing it before the installation process. Please
refer to microSD card installation for more information.
• For best performance, please install the LampCam at a height of 2.5 meters. (Pic.2)

3.2. Micro SD Card installation

Step 1:
At the bottom of the LampCam open the compartment by
unscrewing the screw
Step 2:
Install the SD-Card into the indicated SD-card slot.
Step 3:
Close the compartment by placing the cover and fasting the screw.
NOTE:
The Micro SD card is mandatory for local recording. Please make sure the MicroSD is CLASS10 rated.
Supported are MicroSD cards from 8GB to 128GB.
3.3. Optional: Pre-Installation testing of the LampCam
Before installing it is possible to turn ON the LampCam via the micro USB port with a power bank or 2A
micro USB power supply. Wait until the LampCam makes a double beep tone and the Blue LED indicator
at the bottom of the LampCam starts flashing. (This process would take around 60 seconds, make sure the
LED is flashing in blue). Then refer to chapter "4.1. Learn in a LampCam".
Note: The led light of the LampCam won't turn on when connected via USB.
Pic.1
2.5m Hight
A
.
Pic.2
5m PIR Detection Range
Motion Detection 90°
A
5