Proper Hand Position - MAC TOOLS MPF970501 Manuel D'instructions

PROPER HAND POSITION

WARNING
Warning: To reduce the risk of serious
personal injury, ALWAYS use proper hand
position as shown (Fig. 3).
Warning: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Fig. 3
MAINTENANCE
Lubrication
Air tools require lubrication throughout the lifetime of the tools.
The air hammer mechanism uses compressed air to power the tool. The compressed air contains moisture that
will rust the components inside of the tools, therefore lubrication is required daily. Failure to lubricate the air
tool properly will dramatically shorten the life of the tool and will void the warranty
CAUTION: This air tool requires lubrication BEFORE initial use, also before and after each additional use.
To lubricate the air tool manually:
1. Disconnect the tool from the air supply source, place the air inlet face up.
2. Depress the trigger and place about 5 to 10 drops (0.25 to 0.5 ml) of air tool oil into the air inlet.
NOTE: Use SAE #10 weight oil if air tool oil is not available.
3. Remove accessory, connect the tool to an air source, then cover the exhaust end with a towel and run tool for
2 to 3 seconds.
To lubricate internal mechanism:
Locate the grease fitting in the back of the tool. Inject 4 cc's of MAC tools approved impact grease into the
fitting every 3-6 months depending on use.
WARNING: Keep out of the reach of children. If air tool oil is ingested, do not induce vomiting, call a doctor
immediately.
WARNING: Any excess oil in the tool is immediately expelled from the exhaust port. Always direct exhaust
port away from people or objects.
NOTE: Check the speed and make a simple check of the vibration level after each service.
Storage:
The air tool must be lubricated before storing. Follow the "Lubrication" instruction with exception of step 3.
Always use an air line lubricator with this tool. Do not over-oil and do not use heavy grade oil as stalling and low
performance may result.
8
MACTOOLS.COM