Hardware Installation - König Electronic CMP-MOUSE 200 Mode D'emploi

Smart storage of USB receiver. Open the battery cover and you can easily store the receiver.
LED indicator. Shows activity when active, also flashes when batteries are almost empty.

Hardware installation:

Step 1: Pull down the cover of the battery compartment to open it. Remove the USB receiver.
Step 2: Put two batteries in the compartment. Make sure the polarity is correct.
Step 3: Replace the cover on the compartment.
Step 4: Connect the USB receiver to the USB port of the computer or notebook.
Step 5: Switch the ON/OFF button to ON, then you can start using the mouse.
(There is no need to set the channel, it is plug & play)
Gesture types:
Click with your finger on the left button area, just like with other mice.
3