Getting Started - DNT MusicFly Blue Mode D'emploi

Switch off
The unit switches off automatically after 60 minutes when no
music is played . Alternatively the unit can be switched off
with the
Standby Mode
If no audio device is connected to the USB port, SD card slot
or audio in or the device is in PAUSE mode, the device turns off
after 1 Minute. A noise is heard in the radio. If the audio device
is connected to the MusicFly Blue in the next 60 Minutes, the
device turns itself on automatically, otherwise turn the device
on with the
If the menu for the settings is active, then a LED
below the MENU/F.REPEAT button appears.
Pairing
Refer to the specifi c instructions supplied with your
phone for details on pairing Bluetooth devices.
To use the MusicFly Blue with a mobil phone both devices
have to make a pairing. Turn the Bluetooth in your mobil phone
on. After that initiate a search for new Bluetooth devices.
During this procedure the display indicates
bto The previous display settings appear. The
MusicFly Blue checks whether a device is
attached to the USB port or a SD card is in the
card slot and starts to playback the music.
button
button.
Press the
enter pairing mode. The display shows PAo.
When devices are linked the display shows bto.
Look to the messages in the display of your
mobil phone. The MusicFly Blue will be indi-
cated as MusicFly Blue in your mobil phones
display. If the phone requests for a passkey
enter „0000" or „8888". Thus the pairing is suc-
cessfully fi nished. To cancel the paring press
- 25 -

Getting started

button for 2 seconds to