Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OTHER SETTINGS
Temperature compensation
If your ControlBox24/7 is located where the temperature is consistently a few degrees higher or lower than where you
want to measure it, you can adjust the temperature on the unit.
To compensate the monitored temperature, send the following text message to your ControlBox24/7:
TADJ <X><YY>
= 0 for positive value, 1 for negative value.
X
YY
=
05
0.5°C
1.0°C
If you want your ControlBox24/7 to show 2.5 degrees higher than the actual temperature measured, send the
following text message to the unit.
TADJ 025
Where "0" stands for "+", i.e. the temperature reported will show 2.5°C above the
actual temperature where ControlBox24/7 is located.
If you want to adjust the temperature shown downwards 1.5°, send
TADJ 125
Where "1" stands for "-", i.e. the temperature reported will show 1.5°C below the
actual temperature where ControlBox24/7 is located.
To deactivate temperature compensation, send:
TADJ 000
10
15
20
25
1.5°C
2.0°C
2.5°C
30
35
3.0°C
3.5°C
14
Publicité
Chapitres
Table des Matières
