Les langues disponibles

Les langues disponibles

Signify Classified - Internal
WARNING & IMPORTANT
• This luminaire must be installed in accordance with National Electrical Code and local electrical and
construction regulations.
• To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation.
To prevent electrical shock, turn off electricity at fuse box before installation.
• Product with no frame or installed with non-IC 2RN/2SN frames is not rated for insulation contact and
insulation must be kept 3 inches away from fixture sides and driver sides.
• Product is IC rated when installed with the 2RA/2SA frames only.
• Do not install if luminaire, parts or connectors are damaged.
• Product must be installed with provided or specified drivers and housing only. Use of other manufacturers'
components will void.
Light Engine Kit
Power Supply
STEP 1
Remove knockout from frame with cover
7/13/2021
page
1
www.lightolier.com
NOTE: For the frame with no cover go to step 3 If you want to access the cable management,
please do it from the frame's rear door.
NOTE: For fully compliance apply silicon around to the perimeter of the bottom flanged
aperture.
REV .4 6/24/2021
STEP 2
Pass the wires through the hole. The cables must be
long enough for the dimming and the main cables (6
inches recommended).
442295520871
Calculite 2"
Installation Instruction
Table des Matières
loading

Sommaire des Matières pour SIGNIFY Lightolier 442295520871

  • Page 6: Kit De Moteur Lumière

    Signify Classified - Internal 442295520871 Calculite de 2po Manuel d’installation ⚠ ATTENTION • Cette luminaire doit être installé conformément le Code National Electrique et des régulations électriques locales et de construction. • Pour assurer la conformité avec des codes locales et des régulations, vérifier avec votre inspecteur électrique local avant d’installer.
  • Page 7 Signify Classified - Internal Manuel d’installation de Moteur lumière 442295520871 ÉTAPE 3 ÉTAPE 4 Enlever l’entrée defonçable du driver. Faire passer les câbles dans le trou ⚠ ATTENTION Avant de continuer l’installation, assurez-vous que la couverture du driver est en place, il faut avoir un sol physique et éviter des chocs électriques.
  • Page 8: Anneau Sans Bordure Et Garniture

    Signify Classified - Internal Manuel d’installation de Moteur lumière 442295520871 Alimentation électrique ÉTAPE 7 Schéma de câblage Installer l’alimentation Gradateur ELV électrique au boîtier. Rouge Bleu Rouge Bleu Violet Grise Gradateur Anneau sans bordure et garniture ÉTAPE 1 ÉTAPE 2 Fixer l’anneau au plafond avec quatre...
  • Page 9: Réglage Vertical

    Instruction d’installation. (Réglable) Inclination de 40° Réglage vertical 0° - 40° Fixer l’angle Réglage rotatif 0° - 360° Rotation de 360° Fixer la position 7/13/2021 REMARQUE: Pour les moteurs d'éclairage réglables - Une clé Allen (1,5 mm) fournie par Signify 7/13/2021 page...
  • Page 10 Signify Classified - Internal Manuel d’installation de Moteur lumière 442295520871 Luminaire Maintenance For DL, LW and AA flanged configurations, pull down luminaire (i.e. reverse of installation). For DL and LW flangeless configurations, pull the two springs inward on the inside of the light engine and pull the light engine and driver pod...

Table des Matières