Kichler Rana 310155 Manuel D'instructions page 9

9. ATTACHING THE FAN BLADE/
BLADE ARM ASSEMBLIES
Attach each blade assembly to the motor by using
two mounting screws for each blade assembly.
(Fig. 17)
NOTE
: Make sure these mounting screws are
securely tightened.
10. INSTALLING THE LIGHT KIT PAN
Step 1. Remove one screw from the bracket below
fan motor assembly and loosen but do not remove
the other two screws. (Fig. 18)
Step 2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw heads
fit into the keyholes slots. Turn the light kit pan
clockwise. (Fig. 19)
Step 3. Re-install the screw that was removed in
step 1. (Fig. 19)
NOTE
: Make sure these mounting screws are
securely tightened.
60" Rana
Blade arm
Screws
Fig. 17
Fig. 18
Light kit pan
Screws
Fig. 19
™
8
Blade
Screws